102
Promise
Technology
Pegasus32 Series
Rebuild
When you rebuild a disk array, you are actually rebuilding the data on one physical drive.
•
When a physical drive in a disk array fails and a spare drive of adequate capacity is available, the
disk array begins to rebuild automatically using the spare drive.
•
If there is no spare drive of adequate capacity, but the
Auto Rebuild
function is ENABLED, the disk
array begins to rebuild automatically as soon as you remove the failed physical drive and install an
unconfigured physical drive in the same slot. See
“Making Rebuild Settings” on page 103.
•
If there is no spare drive of adequate capacity and the Auto Rebuild function is DISABLED, you
must replace the failed drive with an unconfigured physical drive, then perform a
Manual Rebuild
.
See “Rebuilding a Disk Array” on page 196 and ”Managing Spare Drives” on page 165. Also see
“Disk Array and Logical Drive Problems” on page 194.
Rebuild Settings
Summary of Contents for Pegasus32 R4
Page 1: ...Pegasus32 R4 R6 R8 Product Manual Version 1 1 2020 Promise Technology Inc All Rights Reserved ...
Page 9: ...ix About this guide Pegasus32 Product Manual WARNING WARNING ...
Page 101: ...85 Managing the Pegasus32 Pegasus32 Product Manual Controller Settings ...
Page 201: ...185 Troubleshooting Pegasus32 Product Manual View NVRAM Events ...