11
Installation and Setup
Pegasus32 Product Manual
Connect Pegasus32 to your Mac
To establish the Thunderbolt™ 3 / USB connection:
1.
Connect a Thunderbolt™ 3 / USB cable from one of the Thunderbolt™ 3 / USB 3.2 Gen 2
(Type-C) ports on the back of the Pegasus32 to the Thunderbolt™ 3 / USB 3.2 (Type-C) port on
your computer.
See
“Thunderbolt™ 3 / USB 3.2 Gen 2 data connection and power connection” on page 10
.
2.
If the Pegasus32 is plugged into a power source and the computer is running, the Pegasus32
will power on and begin to boot up. See “Power modes on the Pegasus32” on page 31 for
information on power up and shut down behavior.
You will notice the following:
• The Power Button LED is lit orange at first, then blue.
•
The drive carrier Power / Status LEDs is lit blue.
•
The Link LED for the port connection is lit blue.
See “Pegasus32 R6 front view” on page 4 for illustration of the front of the device.
•
The “Promise Pegasus” storage drive icon (see picture below) appears on your desktop.
This indicates the Pegasus32 is ready for use.
Note
If the Thunderbolt™ 3 / USB cable is connected to a computer that is running, the
Pegasus32 will power up as soon as the power is connected.
Note
When the device is powered on by connecting the Thunderbolt™ 3 / USB cable, or by
pressing the Power Button, the Power Button turns orange. It takes about 30 seconds
to start the Pegasus32 unit.
Summary of Contents for Pegasus32 R4
Page 1: ...Pegasus32 R4 R6 R8 Product Manual Version 1 1 2020 Promise Technology Inc All Rights Reserved ...
Page 9: ...ix About this guide Pegasus32 Product Manual WARNING WARNING ...
Page 101: ...85 Managing the Pegasus32 Pegasus32 Product Manual Controller Settings ...
Page 201: ...185 Troubleshooting Pegasus32 Product Manual View NVRAM Events ...