24
6. Reset of Default values
Menu-level
Parameter-level
Function for undercutting / exceeding limit value,
FU-2
:
Default:
hi9h
The limit value violation is selected with
Louu
(for LOW = lower limit value) and the one with
HiGH
(for HIGH = upper limit value). Derived from "lower limit" = lower limit value and higher limit =
upper limit value. If, for example, limit value 1 is set to a switching threshold of 100 and
assigned the function
high
the alarm is activated when the switching threshold is reached. If the
limit value is assigned to
Low
an alarm is triggered when the value falls below the switching
threshold, as long as the hysteresis is zero.
Setting the code,
CODE:
Default:
1234
With this setting it is possible to select an individual code (factory setting
1 2 3 4
) for the
programming lock. For programming lock/unlock please proceed according to menu item
run
.
To set the device to a defined basic state, it is possible to perform a reset to the default values. The following
procedure shall be used for this purpose:
• Switch off the voltage supply of the device
• Press
[P]
key
• Switch on the power supply and press the
[P]
key until "- - - -" appears in the display.
Reset loads the default values and uses them for further operation. This returns the device to the state it was
in on delivery.
Attention!
•
All application specific data is lost.
6. Reset of Default value
