21
5.1. switching on
After completing the installation, you can put the device into operation by applying the supply voltage. Check all
electrical connections once again beforehand to ensure that they are connected correctly.
Start sequence
During the switch-on procedure, the segment test (
8 8 8 8
), the message of the software type and subsequently
the software version are displayed for 1 second for the same time. The start sequence is followed by the
change to the operating or display mode.
5.2. Standard parameterization:
The display now changes to the menu level with the first menu item
TYPE
.
5. Setting the display
5. Setting the display
Menu-level
Parameter-level
Type of temperature measurement,
TYPE:
Default:
°C
To display the temperature you can choose between
°
C and
°
F. With
[P]
the selection is
confirmed and the display changes back to the menu level.
Setting the decimal point / dimension sign,
DOT
:
Default:
0.0
The decimal place and the physical unit of the display can be set with [
▼] [▲]. If e.g. the
temperature measurement in
°
C is selected, you can select 0
°
C or 0.0
°
C in the parameter level.
With
[P]
the selection is confirmed and the display changes back to the menu level.
Line adjustment,
offs
:
Default:
000.0
The value for the sensor calibration is adjusted from the smallest to the largest digit with [
▼]
[
▲] and confirmed digit-selectively with
[P]
. After the last digit, the display changes back to the
menu level. The value adjustment for a temperature measurement in
°
C can be set between -
20.0 and +20.0 and for a measurement in
°
F between -36.0 and +36.0. If the type of
measurement is switched later, the value is rounded.
Setting the measuring/display time,
SEC
:
Default:
01.0
The display time is set with [
▲] [▼]. The jumps are in steps of 0.1 up to 1 second and in steps
of 1.0 up to 10.0. With
[P]
the selection is confirmed and the display changes to the menu level.
dann
