6
5. Setting the display
Menu-level
Parameterization level
Setting the display time
SEC
:
Default:
01.0
The display time is set with
[
▲] [▼]
. The jumps are in steps of 0.1 up to 1 second and in steps
of 1.0 up to 10.0. With
[P]
the selection is confirmed and the display changes to the menu level.
5.3. Programming interlock
RUN
Activation/deactivation
of
the
programming
lock
and
completion
of
standard
parameterization
run:
Default:
uloc
Here, [
▲] [▼] can be used to select between deactivated key lock
Uloc
(factory setting) and
activated key lock
Loc
. The selection is made with
[P]
. After this, the display confirms the
settings with "- - - -" and automatically switches to the operating mode. If
Loc
was selected, the
keyboard is locked. To enter the menu level again,
[P]
must be pressed for 3 seconds in the
operating mode. The now appearing
CODE
(factory setting
1 2 3 4
) is entered with [
▲] [▼] and
[P]
and unlocks the keyboard. An incorrect entry is displayed with
FAIL
.
dann
Menu level
Parameterization level
Rescaling the measurement input values,
EndA:
With the help of this function the final value can be rescaled to e.g. 19.5 mA input signal without
applying the measuring signal. These parameters are not available when sensor calibration is
selected.
Rescaling the measurement input values,
OFFA:
With the help of this function the initial value can be rescaled to e.g. 3.5 mA input signal without
applying the measuring signal. These parameters are not available when sensor calibration is
selected.
5.4. Extended parameterization
If the [
▲] & [▼] keys are pressed for one second during standard parameterization, the display changes to the
extended parameterization mode. Operation is the same as in the standard parameterization.
