Projectiondesign WB1920, User Manual

Page: 13 / 62

english
13
www.projectiondesign.com
4.4 LED indicators / Front button
The front button and the Power and Status LED-indicators on the processor front panel have
the following functions:
Front button: Power LED: Status LED:
Push 1 time:
Show info on screen
(visual ID/IP/present serial no.)
BLUE: ON GREEN: ON
Push 3 times: Reboot
BLUE: Blinking
• Booting up
GREEN: Blinking
• DVI IN not valid and/or
• Network not OK
Press and hold
5 seconds:
Network reset
YELLOW: Blinking
• Upgrading software
RED: ON
• Temperature too high
Press and hold
15 seconds:
Factory reset
Figure 4-3. Front button and LED-indicators
4.5 Network settings
For optimum performance during calibration, a 1.0 Gbps Ethernet connection is
recommended. 100 Mbps will also give adequate performance.
The communication between the control PC and multi image processing system units is
based on a bidirectional XML protocol. We recommend that any firewall between Control PC
and multi image processing system units should be disabled.
Multi image processing system processors support DHCP in a network environment. Static
IP addresses can be set if there is no DHCP server available. Processors also support Zero
configuration networking (zeroconf).
Note! It is recommended that the multi image processing system processors and the
ProNet Control PC are run in a dedicated network environment.