58
PRODIGIT
BIT ID
BIT VALUE
REMARK
bit 0
0 = Off, 1 = Triggered
Over Power Protection (OPP)
bit 1
0 = Off, 1 = Triggered
Over Temperature Protection (OTP)
bit 2
0 = Off, 1 = Triggered
Over Voltage Protection (OVP)
bit 3
0 = Off, 1 = Triggered
Over Current Protection (OCP)
TABLE 4-11 REGISTER of Protection Status
[STATe
：
] CCR {AUTO
R2}
Command Syntax
:
[STATe
：
] CCR {AUTO
R2} {
；
NL}
Purpose:
Set the CC MODE RANGE, forcing RANGE II operation if required.
Description
: Swaps the unit between AUTO RANGE and RANGE II. AUTO RANGE
Will allow the unit to move to the more precise range at low currents,
While forcing the unit to remain in RANGE II keeps the range consistent
Regardless of the current.
[STATe
：
] POLAR {POS
NEG}
Command Syntax
:
[STATe
：
] POLAR {POS
NEG} {
；
NL}
Purpose:
Sets the polarity displayed by the voltage meter.
Description
: The voltage read-out can be set to POS for positive, and NEG for
Negative polarity display.
[STATe
：
] START
Command Syntax
:
[STATe
：
]START {
；
NL}
Purpose:
Set for Load to begin the test.
Description
: Begins the test, according to the TEST CONFIG(TCONFIG), the load
Module will start to test the items and parameters as stored.
[STATe
：
] STOP
Command Syntax
:
[STATe
：
]STOP {
；
NL}
Purpose:
Stops the test, if one is in progress.
4.6.4.
SYSTEM
functions allows the user to read the part number of the
Load modules and turn RS232 control ON and OFF. Commands are also
Available for storing and retrieving load set-ups saved in the memory of the
Mainframe. The mainframe has 150 separate memory locations. This is
Comprised of 15 memory BANKS with each bank having 10 STATES.
331XF
333XF
334XF/G
33401F/G
BANK(n)
15
15
15
15
STATE(m)
10
10
10
10
TOTAL STATE
150
150
150
150
