71
>>
INstallatIoN oF tHe FIltRatIoN system
caUtion
w
the pump power
supply must be
protected by a 30ma
differential circuit
breaker upstream
from the installation.
w
The installation described is a standard installation with the filtration group located
3.5 m from the pool as required by the safety standards in effect. You may need to alter
the lengths of the tubes to adapt to the configuration of your terrain, the position of
your pool (above-ground, partially in-ground or in-ground), the type of plant housing
or a number of other installation constraints.
w
For the installation, refer to the sand filter assembly instructions below and the
operating guide enclosed with the pump. Examine the diagram of the filtration
system that shows the various elements and connections.
WARNINGS :
The filtration system provided in the kit, and every other electrical device, must
be wired in according to the French standard C15-100.
do not hesitate to call in a professional to guarantee the compliance of your
installation.
PRECAUTIONS AND ADVICE:
Barrel unions (isolating valves) should be tightened by hand only, no tools are
required. In fact, excessive tightening can damage the threading or twist the seals
leading to leaks.
Wrap 3 or 4 turns of sealing tape around connections that have no seals.
Only the collar clamps (type cerflex) need to be tightened with a crosshead
screwdriver. Do not over tighten. Do not forget the rubber bands designed to cover
the collar clamps.
w
installation of
the filter below
the water liner
is strongly
recommended.
above the water
line there is a risk
of deformation due
to depressurisation.
the maximum
allowed is level with
the coping. in the
event that the filter
is installed above
the water line, a
flap valve must be
installed on the
return line and an
easily accessible
check valve must
be installed on the
suction line (these
items are available
from all pool
specialists).
40021008 aquareva skimmer flow regulator plug
2
aquareva skimmer weir, couleur
2
40261003 skimmer sl119-p pre-fix flange, white 2
return fitting and vacuum point flange, liner, couleur 4
sf - trim union ball for aquareva nozzle, colour
2
sf - aquareva vacuum point face trim, couleur
1
spa main drain/ grate sf-100aV
1
7614230 pozi countersunk head screw M5x16 a4 Din 965 a 16
7616070 pozi countersunk head wood screw 3x25 a4
36
40051035 aquareva WM skimmer screws, set of 25 csH 5.5x25 2
40051037 aquareva wide mouth skimmer flange gasket
4
40261005 set of screws panel/4 nuts-washers-screws M5x60
3
40261001 cut pipe for skimmer panel/liner sl119Wood, 325mm 2
42000005 aquareva return fitting/vac point flange gasket
8
48403668 skin: aquareva pool fittings pro gf6, blue
48403568 skin: aquareva pool fittings pro gf6, grey
48403768 skin: aquareva pool fittings pro gf6, sand
