79
figure 68
figure 65
figure 66
figure 67
w
the wooden ladder
is a safety element.
Don’t forget to
remove it after
bathing!
w
apply the self-
adhesive label
recalling this
instruction to the
wall of the pool !
caUtion
>>
laddeRs
figure 69
w
Assemble the wooden ladder as illustrated, use screws from bag (K)
w
The wooden ladder is held in place by hooks attached under the coping and a lever
mechanism attached to the saddle of the ladder. Fastening mechanism may differ from
that illustrated but will function according to the same principle.
w
Assemble the various parts of the ladder referring to the installation instructions
provided. When mounting the hand rails, do not forget the two rubber seals that will
be used to hold the decorative escutcheon plates in position.
w
Position the ladder in the pool on the coping module of your choice (except the wall
holding the skimmer and counterswim module), remember that it should be opposite
the wooden ladder.
Adjust the position of the ladder paying particular attention to ensure that it is vertical
and that the bumpers are pressed firmly against the inside wall.
Mark the positions for drilling. Remove the ladder and drill.
Fix the ladder in place according to the instructions provided, the counter plate
should be positioned under the coping (additional bag in the Filtration pack). Tighten
moderately.
Slide the 2 rubber seals along the tubes so that they hold the escutcheon plates in
position.
figure 70
w
the maximum
weight supported by
the ladder is 150 kg.
O-RInG
FLAnGE
ESCUTCHEOn
PLATE
COUnTER
PLATE
