73
w
Screw the rigid descending pipes C onto the return fitting elbows. do not forget to
check that the o-rings are in place.
w
Cut the rigid descending pipe for the vacuum point (as indicated earlier and according
to the height of your pool) and mount it.
return fitting rigid
descending pipe
Vacuum fitting rigid
descending pipe
figure 45
figure 46
InSTALLATIOn OF THE FILTER
TO OPTIMISE FILTRATIOn
And PROTECT yOUR
SySTEM, only use sand with
a grain size of 0.6/1.25!
The sand should not reach
higher than 2/3 of the way
up the filter tank.
figure 47
w
Once the filter has been filled with sand and the multi-port valve has been mounted,
screw the isolating module (K), the barbed unions (S) (found in the Connections skin)
and the pressure gauge onto the 6-way valve. Use of Teflon on all these connections is
mandatory.
caUtion
w
Before installling the filter and, notably, filling it with sand, make sure that it is correctly
positioned on its base and in it’s designated site. Check that the drain plug is in.
w
Refer to the instructions enclosed with the filter for information on how to fill it with filter
medium and install the 6-way valve.
MOUnTInG THE RIGId dESCEndInG PIPES (COnT.)
K
S
S
K
S
S
