Printronix L1024, Maintenance Manual

Page: 62 / 372

5–16 Chapter 5 – Transfer Subsystem
(For Steps 2 through 4 following, refer to Figure 5–3 on page 5–9.)
2. Remove the Front Plastic Paper Guide from the Transfer Charger by pressing down on the
ends of the Paper Guide and sliding it to the left. This disengages the Locking Tabs and the
Paper Guide can then be easily removed.
3. Remove the Transfer Charger Paper Guide by gently pressing the Release Tabs at the rear of
the Guide toward the front of the Printer. Lift the rear of the Paper Guide to clear the Tabs of
the Slots, and release the Front Tabs by rotating the Paper Guide toward the front of the
Printer.
4. Remove 4 Screws from the bottom of the Transfer Charger. Remove the Charger from the
Printer by lifting the front of the unit and rotating it toward the rear of the Printer. This makes it
easier to disengage the Swing Shaft from the Engagement Lever.
See Detail 5–1 on page
5–10 .
5. Remove the plastic Fuser Heat Shield. See Figure 5–5.
6. Remove the Lamp Connector Cover by removing 1 Screw and sliding the cover toward the
fuser. Disconnect the Fuser Lamp and Thermistor Connectors from the Stepper Motor Board
Frame.
See Figure 5–5 and Detail 5–4.