Printronix L1024, Maintenance Manual

Page: 251 / 372

12–31 Chapter 12 – Covers, Frame, and Backplane Board
10. Remove 2 Screws from the rear of the Base Frame, then lift the LVPS slightly to clear the
Base Frame (1). Push the Power Switch to the OFF position (2), then slide the LVPS toward
the rear of the printer (3).
Use care to avoid damaging the Power Switch. Once the Power
Switch is partially past the Frame, switch it to the ON position (4), then slide the LVPS free of
the Base Frame (5).
See Figure 12–13.
CAUTION: Use care to avoid damaging the Fuser Lamp Connector. Ensure that it
does not catch on the Base Plate. When reinstalling the Lamp, be
sure that you route the Fuser Lamp Connector through the Base Plate
before you install the LVPS into the Base Frame.
See Figure 12–14.
NOTE: When installing the LVPS, ensure that the bottom front of the Supply is
locked under the Locking Tabs on the Base Frame.
See Figure 12–15.