Printronix L1024, Maintenance Manual

Page: 17 / 372

1–7 Chapter 1 – Introduction
Cleaning
Area Method
Cleaning
Tool
Frequency
Fuser
Heat Roller;
Transfer
Corona Wire;
Charge
Corona Wire When replacing Felt
Wipers and when
replacing Developer
Unit Refer to the
Setup Guide. Refer to the Setup Guide.
Inside
Cleaning 30,000 pages Wet Wipe
Tissue Remove paper powder and toner from the
areas listed below:
S
Transfer Charger around the mylar sheet
(wipe the mylar first, then use the brush
for the wire)
S
Around the Tractor
S
Inside the right cover
S
High Voltage Power Supply cover
S
Fuser paper guide
S
Transfer paper guide
S
Paper guide inlet
S
Front paper guide (if installed)
LSU
Cover Glass 300,000 pages Cotton Swab
and Rubbing
Alcohol Wipe the LSU Cover Glass with a cotton
swab containing anhydrous rubbing alcohol.
Rub the glass in one direction only (either
from right-to-left or from left-to-right).
Repeat this process, using a new cotton
swab each time, until the glass is
completely clean.