Printronix L1024, Maintenance Manual

Page: 258 / 372

12–38 Chapter 12 – Covers, Frame, and Backplane Board
18. Remove the Tractor Paper Guide by removing 1 Screw from the center rear of the Tractor
Frame. See Figure 12–18.
19. Open the Paper Exit Guide of the Fuser Base so that it is not in contact with the Fuser Roller
Assembly.
20. Depress the Fuser Roller Retaining Lever on each side of the printer so that the Fuser Roller
Assembly is free to move.
See Figure 12–18.
21. Lift the Fuser Roller Assembly free of the Fuser Base, then remove it from the printer. See
Figure 12–18 .
22. Disconnect the Fuser Sensor Board by removing the Cable at Connector J1.
See Figure
12–18
.
23. Open the Printer Front Cover, then remove the LCD Control Panel by removing 2 Screws.
See Figure 12–18.
24. Remove the Right Side Cover by removing 3 Screws.
See Figure 12–18.
25. Remove 2 Screws from the rear of the Fuser Base and remove it from the printer. See Figure
12–18 .
26. Remove 2 Screws from the Ozone Filter Case and remove it from the printer.
See Figure
12–19
.