BeamMonitor BM+
35,0(6
14
Revision 02 EN - 02/2022
7
Mounting
7.1
Conditions at the installation site
• The device must not be operated in a condensing atmosphere.
• The ambient air must be free of organic gases.
• Protect the device from splashes of water and dust.
• Operate the device in closed rooms only.
7.2
Installation in the laser system
7.2.1
Prepare mounting
Check the space available before installing the device, especially the required space for the connec-
tion cables. The device must be firmly installed and must be mounted with screws (see chapter 7.2.4 on
page 15).
DANGER
Fire and explosion hazards due to scattered or directed laser radiation
When the BeamMonitor BM+ is being operated, the irradiation must be fully absorbed behind the
measurement zone. Fire bricks or other partly-absorbing surfaces are not suitable.
X
Use an adequate absorber. Dependent on the application, PRIMES offers suitable laser power me-
ters, such as the PowerMonitor PM 48/100.
7.2.2
Possible mounting positions
The BeamMonitor BM+ can be mounted horizontally or vertically.
Beam incidence
Mounting surface
Mounting surface
BeamMonitor BM+
Mounting surface
Beam incidence
Mounting surface
BeamMonitor BM+
Horizontal installation
Vertical installation
Mounting surface
Beam incidence
Mounting surface
BeamMonitor BM+
Beam incidence
Mounting surface
BeamMonitor BM+
Mounting surface
Fig. 7.1:
Possible mounting positions of the device
