58
6
The Fat Channel
StudioLive™ Series III
6.8
Fat Channel Screens
Owner’s Manual
6.8.2
Channel Settings Screen
图像
When the overview screen for a channel or bus is open, can access the Channel
Settings screen by tapping on the Settings button (Call-out #3).
当打开通道或总线概况图像时，通过点击
Settings
按钮（
Call-out #3
）进入
Channel Settings screen
。
1
5
2
3
4
1.
Channel Name.
Touch the
name field
to enter a new name with the onscreen
keyboard.
触碰
name field
，用屏幕键盘输入一个新的名称。
2.
Channel Type.
Touch the
type field
to choose between the standard identifying
channel types (such as Guitars or Drums).
触碰
type field
和标准识别通道类型（如吉他或鼓）之间选择。
3.
Digital Send Options.
Touch
Pre
(signal is sent before Fat Channel processing)
or Post (signal is sent after Fat Channel Processing) to choose the signal routing
when sending this channel or bus to a USB or network-connected audio device.
触碰
Pre
（信号在
Fat Channel
处理前发送）或
Post
（信号在
Fat Channel
处
理后发送），可以将此通道或总线发送到
USB
或网络连接的音频设备时，
选择信号路由。
4.
Channel Color.
Sets the color of a channel’s Select button. If no color is selected,
the Select button will be blue.
设置通道的
Select
按钮的颜色。如没有所选颜色，
Select
按钮将是蓝色的。
5.
Stereo Link Options.
These options let you specify the linking behavior when
you link pairs of channels or buses, with the following options:
链接成对的通道或总线时，这些选项让你指定链接，有以下选项：
-
Preamp Level/Trim.
Enable this option to link preamp level and trim
settings when channels are linked. Disable to allow these settings to be
individually set for each linked channel.
启用这个选项，当通道被链接时，可以链接前置放大器的电平和
trim
设置。禁用，允许为每个链接的通道单独设置这些设置。
-
Panning.
Enable this option for “stereo” panning mode, which lets you
use the pan controls on linked channels or buses to control overall stereo
“width.”Moving a pan control on a linked channel moves the corresponding
pan control the same amount in the opposite direction. Disable this option
to allow independent panning of linked channels or buses.
启用这个选项，可以实现
"stereo"
的
panning
模式，使用链接通道或
总线上的
pan
控制，来控制整体的立体声
"width"
。移动链接通道上
的
pan
控制，会在相反的方向移动相应的
pan
控制。禁用这个选项，
允许链接的通道或总线单独
panning
。
-
Fader Levels.
Enable this option to link volume faders for linked pairs of
channels or buses. Disable it to allow independent manipulation of fader
levels for linked channels.
启用该选项，可以将成对的通道或总线的音量推子连接起来。仅用
可允许单独操作链接通道的推子。
