Precor Experience 700 line Series, Service Manual

Page: 188 / 232

E-Stop not Communicating Troubleshooting
An error 37 may occur after an E-STOP event. If the E-STOP event is not successfully cleared
in the lower PCA and the upper display believes the E-STOP has been cleared, a error 37 will
occur. Possible causes include pulling and resetting the E-STOP twice within the 10 second
time-out period, pulling the E-STOP, turning off the treadmill, turning the treadmill back on,
and then starting a course, or pulling the E-STOP, turning off the treadmill, reset the E-STOP,
turning the treadmill back on, and then starting a course. Also possible is a break in the E-
STOP line, or a loose cable connection.
Related Error Codes
RELATED
ERROR CODE DESCRIPTION
37 E-STOP Upper PCA/Lower PCA Mismatch
Troubleshooting Procedure
Review the machine Error Log or CPA
1
Event Log and note any possible issue related error
codes. Then use the Error Code and Troubleshooting Guide to learn about these error codes
and procedures to troubleshoot and repair the issue, see Error Code Troubleshooting Guide .
See Also
"System Troubleshooting Procedures" on page 166
1
Control Processing Assembly
Page 180
6 Troubleshooting
System Troubleshooting Procedures