Precor Experience 700 line Series, Service Manual

Page: 187 / 232

Auto Stop Troubleshooting
Apple To: TRM800-14, TRM700-16 and later treadmill models
This troubleshooting procedure only applies to TRM800-14, TRM700-16 and later treadmill
models that utilize software and drive motor current input to manage the auto stop function.
For early production models like the TRM10 treadmill that utilize mechanical magnetic sensor
input to manage the auto stop function, refer to the
Error Code Troubleshooting Guide for
troubleshooting information.
Auto stop is a safety feature that shuts off a treadmill that has been abandoned while the belt is
running. Exclusive of the first sixty seconds after a workout has begun or resumed, any 30
second window with no user detected will prompt a 10 second countdown and then a full stop.
The detection is accomplished through software, and is rated to detect persons weighing 50
lbs (22.7kg) or greater walking with a normal cadence.
The feature is selectable ON or OFF in the facility settings menus. It is default from the factory
set to ON, and it is recommended to be set ON.
Related Error Codes
RELATED
ERROR CODE DESCRIPTION
none
Troubleshooting Procedure
Access the Hardware Validation (5,1,7,6,5,7,6,1), and select the Auto Stop test.
P10, P20, and P30 consoles:
When the feature is enabled, the " USER DETECTED" message is shown if motion is detec-
ted from the running deck or NO USER DETECTED if no motion is detected. It may take 5 or
6 steps for the USER DETECTED message to be displayed. This cycle will start over if the
speed is changed.
P62, P80, and P82 consoles:
When START is pressed, after a few steps the status line will show USER DETECTED and
the STEP COUNT will indicate the number of steps. If steps are not detected, the NO USER
DETECTED message will be shown in the status field.
If the Auto Stop Feature did not pass the test replace the motor controller module.
See Also
"System Troubleshooting Procedures" on page 166
Page 179
6 Troubleshooting
System Troubleshooting Procedures