Precor Experience 700 line Series, Service Manual

Page: 159 / 232

1. Connect the power cord and switch the power ON. Be aware that switching the power
ON will cause the incline platform to move and return to the level "0" position. If you are
using the side access method, see
"Side lift platform assembly access" on page 53 to
upright the treadmill.
WARNING : Keep hands and appendages clear of the incline platform
assembly before switching power ON. Switching power ON will cause the
incline platform to move to the level "0" Home position.
2. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
3. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
4. Lower the incline to level "0".
Operation Verification
5. Verify the treadmill incline operation from minimum to maximum levels.Make sure that
there are no active Incline function related error codes.
6. Reinstall the left and right trim side covers see "Covers and Panels Replacement" on
page 58 .
7. Reinstall the left/right trim landing covers, see "Trim Landing Covers Replacement" on
page 63 .
8. Reinstall the hood cover, see "Hood Cover Replacement" on page 60 .
9. Do the Operation Verification tests (see "Operation Verification" on page 16 ) and return
to service.
Page 151
5 Replacement Procedures
Lift Platform Replacement