Chapter 5 Function parameter
86
Ch
ap
ter 5
There are 32 parameters available for viewing, select desired status parameters according to
F6.01, F6.02 binary parameter values, the display order starts from the lowest level of F6.01.
F6.03 Stop status display parameters
0x0001~0xFFFF
0033
☆
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
DI input situation
Bus voltage
(V)
Setting frequency
DO output situation
AI1 voltage
AI2 voltage
(Hz)
Count value
Remain
Length
Load speed
PID setting
(V)
(V)
PLC range
High speed pulse
input frequency(Hz)
Remain
Remain
Remain
Diagram 5-17:
Stop status
If the above parameters need to be displayed on operation, firstly set its position to 1, and
then set at F6.03 after converting the binary number to the hexadecimal number.
F6.04 Load speed display coefficient
0.0001~6.5000
3.0000
☆
When load speed needs to be displayed, adjust the inverter's output frequency and load speed
by using the parameter.
Pls refer to the F6.05 for the specific correspondence
F6.05 Decimal places for load speed display
0 decimal place
0
1
☆
1 decimal place
1
2 decimal places
2
3 decimal places
3
Decimal places for load speed display The below example illustrates the calculation of load
speed:
If the load speed coefficient(F6.04) is 3.000, the number of decimal places of load
speed(F6.05) is 2 (0 decimal places), when the inverter operating frequency reaches 40.00Hz, the
load speed is : 40.00 * 3.000 = 1200 (0 decimal places display).If the inverter is shutdown, the
load speed displays the speed relative to the set frequency, that is the "set load speed". If the set
frequency is 50.00Hz, the load speed under the state of shutdown: 50.00 * 3.000 = 1500 (0 decimal
places display)
F6.06 Inverter module radiator temperature
0.0
℃
~100.0
℃
-
●
Display the inverter module IGBT temperature.The different models of the inverter module
vary IGBT overtemperature protection values.
F6.07 Total run time
0h~65535h
-
●
Display the total run time of inverter When the run time reaches the set time(F7.21), the
inverter's multi-function digital output function (12) outputs ON signal.
F6.08 Total power-on time
0~65535h
-
●
Show the total time of inverter power-on, When the power-on time reaches the set
time(F7.20), the inverter‟s multi-function digital output function(24) outputs ON signal.
F6.09 Total power consumption
0~65535
℃
-
●
Display the total power consumption of inverter to date until now
F6.10 Part number
Inverter product number
-
●
F6.11 Software version number
Control panel software version number
-
●
F6.12~
F6.15
Reserve
F6.16 Monitor selection 2
1Kbit/100bit
10bit/1bit
d0.04
●
parameter number parameter series number
The parameter of motor selection2 can be showed in the bottom of double LED or LCD.
F6.17 Power correction coefficient
0.00~10.00
1.00
☆
Frequency converter with motor running, the display output power(d0.05)is different with the
actual output power, through the parameters, adjust the converter display power and the actual
