73
10. Slide the spring in until the end bottoms in the cutout provided for it in the top of the
bearing block. See B on Figure 4-63.
11. Remove the special tool.
12. Install the other load spring in the same manner.
13. Using tweezers, lift the ends of the edge control springs onto of the holes in the platform.
14.Using long-nose pliers, squeeze the slotted projection of the edge control bar (C and D)
on Figure 4-65 until the bar can be drawn free of the platform. The spring will be released.
15. To replace the components, place the spring in position on the platform.
16. Place the edge control in position and press the center of the bar until the projections
(C and D) lock into the center hold.
B. Adapter Frame - Disassembly/Reassembly
Note: Refer to Figure 4-66 to identify items called out below in parentheses.
1. Remove and retain eight screws (3) holding the adapter frame (2) to the film pack holder
part of the camera door assembly. The adapter frame is now free. Remove and retain the
light seal (6), spring (5) and sponge (4).
Note:
Before reassembling the film holder, examine the metal adapter frame and
the plastic film pack holder. Check that the mating surfaces are flat. If either part
is warped or bowed, replace it. Misalignment of these mating surfaces can cause
the film to be out of focus.
2. Align the adapter frame to the film pack holder. Replace the dark slide light seal (6),
spring (5) and sponge (4). Place the dark slide into the green recess on the adapter
frame (2).
3. Secure the adapter frame (2), using the eight screws previously removed and retained.
4. Pull the dark slide. Be sure it works smoothly.
5. Test for light leaks:
a. Load a pack of 107 film into the film holder.
b. Be sure that the dark slide and door are fully closed and pull the safety cover from the pack.
c. Using bright 150 watt lamp, "paint" the film holder with light for one minute, three feet
from film holder.
Summary of Contents for 600SE
Page 7: ...7 NOTES...
