56
Removing Range Lever Upper Spring
(Figure 4-43)
Release spring so that both ends rest on back wall of camera body. Remove screw and
spring.
Figure 4-43. Removing range lever upper spring
Removing Middle Lever
(Figure 4-44)
Release spring. Use blade of screwdriver to remove middle lever shaft.
Note: Changing middle lever eccentric adjustment will require readjustment of VF/RF
near range setting.
Pull middle lever from shaft. Remove two Phillips head screws. Lift off base plate.
Removing Camera Body Sealing Sponges
(Figure 4-45)
The back sealing sponge is accessible after film holder has been removed (Figure 4-1).
Remove front panel as shown in Figure 4-36. The sponges are cemented in place. Use 1/8"
(.33cm) chisel to scrape sponge and cement from groove; clean with trichloroethylene
thoroughly before replacing sponges.
Parallax
Relay Lever
Range Lever Upper
Middle Lever
Back Wall
Screw
Spring
Back Wall
Camera Body
Camera
Body
Range Lever
Upper Spring
Summary of Contents for 600SE
Page 7: ...7 NOTES...
