60
Removing PC Flash Connector Socket
(Figure 4-50)
Use Phillips screwdriver to remove two screws holding PC flash connector socket to the lens
assembly. Gently pull the free connecting wire away from the lens assembly with the connector
attached. Loosen slot head screw under the connector. Slide out the contact lug.
Figure 4-50. Removing PC flash connector socket
Removing Seiko 884 Shutter From 127MM and 150MM Lens
(Figures 4-51 through 4-53)
Note: Any disassembly or adjustment of the lens system must be followed by lens
collimation check and RF/VF adjustment.
Release contact lug from PC flash connector socket as shown in Figure 4-50. Remove the lens
assembly from the camera body, as previously described for model 600SE.
The shutter is held to the lens assembly by the retaining nut shown in Figure 4-51. The lens
spanner wrench, special tool no. 12459 will reach the retaining nut through the model 600 camera
body.
Work on a clean soft surface. Use the lens spanner wrench special tool no. 12459 to reach
through the rear of the lens assembly and screw off the retaining nut.
PC Flash
Connector Socket
Screw
Contact Lug
Connecting
Wire
Screws (2)
Mount for
Connector Socket
Lens Assembly
Summary of Contents for 600SE
Page 7: ...7 NOTES...
