Polaris 2005 Sportsman MV7, Service Manual

Page: 123 / 312

FUEL SYSTEM / CARBURETION
4.5
SPECIAL TOOLS
PART NUMBER TOOL
DESCRIPTION
2870975 Mity Vac
t
Pressure Test Tool
2872314 Carburetor Float
Adjustment Tool
WARNING
Gasoline is extremely flammable and explosive under
certain conditions.
Always stop the engine and refuel
outdoors or in a well ventilated area.
Do not overfill the tank. The tank is at
full capacity when the fuel reaches the
bottom of the filler neck. Leave room
for expansion of fuel.
Never start the engine or let it run in an
enclosed area. Gasoline powered engine
exhaust fumes are poisonous and can
cause loss of consciousness and death in
a short time.
Never drain the float bowl when the engine
is hot. Severe burns may result.
Do not smoke or allow open flames or
sparks in or near the area where refueling
is performed or where gasoline is stored.
If you get gasoline in your eyes or if you
should swallow gasoline, seek medical
attention immediately.
If you spill gasoline on your skin or clothing,
immediately wash with soap and water and
change clothing.
JETTING GUIDELINES
Changes in altitude and temperature affect air density,
which is essentially the amount of oxygen available for
combustion. In low elevations and cold temperatures,
the air is more dense and has more oxygen. In higher
elevations and higher temperatures, the air is less
dense with reduced oxygen.
Polaris ATV Carburetors are calibrated for an altitude
of 0-6000 ft. (0-1800 meters) and ambient
temperatures b40 and +80
°
F (+5
°
to +26
°
C). Carburetors must be re-calibrated if operated
outside this temperature and/or altitude range. The
jetting installed in production is not intended for all
altitudes and/or temperatures. In addition, air screw
/ pilot screw adjustments and PVT adjustments may
be required to suit operating conditions.
CARBURETOR JETTING
CAUTION:
A main jet that is too small will cause a lean
operating condition resulting in serious engine
damage. Select the correct main jet carefully for
elevation and temperature according to the
charts in the specifications section or in the
Owner’s Safety and Maintenance Manual for each
particular model.
IMPORTANT:
The following guidelines must be
followed when establishing a main jet setting:
1. Select the lowest anticipated temperature at
which the machine will be operated.
2. Determine the lowest approximate altitude at
which the machine will be operated.
3. Select the correct main jet from the chart on Page
1.4.
4. Clutching changes may also be required for
changes in elevation. Refer to clutching chart in
the specifications section for recommendations.
MIKUNI JET PART NUMBERS
Main Jets
Jet Number Part Number
112.5
3130554
115 3130555
117.5 3130556
120 3130557
122.5 3130558
125 3130559
127.5 3130560
130 3130561
132.5 3130562
135 3130563
137.5 3130564
140 3130527
142.5 3130566
145 3130567
147.5 3130568
150 3130569
152.5 3130570
155 3130571
157.5 3130572
160 3131141
162.5 3131142
165 3131143
167.5
3131144
170 3131145
Jet Number Part Number
40.0
3130624
42.5 3130526
Pilot Jets