Automist Smartscan Hydra
®
DIOM Manual - version 3.01.0
Plumis Ltd Copyright © 2020. All Rights Reserved.
Page 46 of 116
S MA RT SC AN
®
o
Minimum curvature working radius: 100mm
o
Robust rubberised exterior and single or double wire braiding to withstand heavy
abrasion during installation and maintenance works and attempts to hammer a nail
through from an adjacent wall.
o
Single braided: SKU 11011404, Egeflex 1 CO
o
Double braided: SKU 11021404, Egeflex 2 CO
o
Weblink:
https://www.hydroscand.co.uk/uk_en/product/egeflex-1-co-1101-14
o
Hose must be tested at Hydroscand after crimping to minimum 160 bar. In this case, no
site testing is necessary.
b)
Hose with 5/16" Inner Diameter
Multiple hose pieces can be connected by tee or connector with 1/4” BSP connection.
Hydroscand supplied 5/16” hose with customized length:
o
Minimum curvature working radius: 115mm
o
Robust rubberised exterior and single or double wire braiding to withstand heavy
abrasion during installation and maintenance works and attempts to hammer a nail
through from an adjacent wall.
o
Single braided: SKU 11011405, Egeflex 1 CO
o
Double braided: SKU 11021405, Egeflex 2 CO
o
Weblink:
https://www.hydroscand.co.uk/uk_en/product/egeflex-2-co-1102-14
o
Hose must be tested at Hydroscand after crimping to minimum 160 bar. In this case, no
site testing is necessary.
o
Use 1/4” BSP inlet fittings with a 5/16” Diameter hose and ferrules
Stainless Steel Piping (alternative to high pressure hose)
•
Material: Stainless steel only
•
Stainless steel pipes and fittings must conform to
o
UK (BS 8458:2015): ASTM A269-10 and ASTM A312
o
US (NFPA 750): ASTM A269 or ASTM A 632 or ASTM A 778 or ASTM A 789/ A 789M
•
Internal diameter: 5/16” (8 mm)
•
Working pressure at least: 150 bar
•
Maximum total length: 50m
Hoses, Piping support
Hose or pipework supports should meet the following recommendations.
a)
Hose or pipework supports should be fixed directly to the structural elements or primary supports
of the building.
b)
Hose or pipework supports should not be used to support any other services.
c)
Hose or pipework supports should prevent the pipe from being dislodged.
d)
Supports should be secured in accordance with the manufacturer’s instructions.
e)
Supports should not be glued, welded, or soldered to the pipe, hose, or fittings.
