Pleora Technologies iPORT CL-GigE, User Manual

Page: 22 / 118

12 iPORT CL-GigE External Frame Grabber User Guide
Connector and Switch Locations
The following figures and table describe the CL-GigE connectors and switches.
Camera Link connector
Differential Type switch
I/O Level switch
RJ-45 connector
12-pin GPIO
connector
In mountable enclosure
In mountable enclosure OEM board set*
*GPIO board assembly with soldered 12-pin connector and flat flex cable shown.
I/O Level switch
Differential Type
Camera Link connector (CL1)
OEM board set
switch
RJ-45 connector
12-pin GPIO
connector
(CL1)
Table 5: Connectors and Switches
Component Type Description
CL1 connector Miniature Camera Link
(MiniCL) connector Provides connection to a Camera Link Base camera. Serial communication on this
connector is mapped to the Bulk0 serial communication interface of the CL-GigE.
When PoCL is enabled, the CL-GigE can supply 4 W at 12 V to the Camera Link
connector, as outlined in the
Camera Link Standard .
For more information, see “Camera Link Connector” on page 13.
GPIO connector 12-pin circular connector Provides power and I/O signals to the CL-GigE.
For more information, see “12-Pin GPIO Connector” on page 16.
RJ-45 connector RJ-45 Ethernet connector Interfaces the CL-GigE to Ethernet networks, as specified in IEEE 802.3.
The Ethernet interface can operate at 100 or 1000 Mbps, and supports Internet
Protocol Version 4 (IPv4).
Differential Type
switch 3-position DIP switch Selects the termination type for differential inputs.
For more information, see “Differential Type and I/O Level Switches” on page 19.
I/O Level switch 2-position DIP switch Selects the voltage for single-ended GPIO inputs and outputs (3.3 V or 5 V).
For more information, see “Differential Type and I/O Level Switches” on page 19.