INSTALLATION
AND POSITIONING
Unwrapping your hot tub
The information within this section is for the installation team. For further information on where to position the
hot tub please read the Pre-Delivery guide.
Remove filter tray & cartridges
Slide filter face upwards, then remove filter
tray cover / take off filter lid and filter cartridges
before filling. The number of filter cartridges varies
depending on the model.
Inspect for damage
Carefully unwrap the hot tub and thoroughly inspect
it for any damage. If you notice any transit damage to
the product, please photograph the damage, keep all
paperwork/labels and contact the retailer from which
the hot tub was purchased immediately.
Wipe out excess water
Your hot tub has been thoroughly factory tested
during the manufacturing process to ensure
maximum reliability and long-term satisfaction. Wipe
out any excess water from the hot tub that may have
drained from the plumbing after testing and make
sure it is clean prior to filling.
Rotate jets
Check the jets are fully secure and fitted into
place before using the hot tub. Each jet had a
quarter of a turn to turn the jet off and on. If you
twist the jet anti clockwise harder then usual the
jet will unscrew and come out
Check pump connection and release valves
Prior to filling your hot tub, remove the side panels
where the engine compartment and control equipment
are situated. Ensure all your pump connections are
tight and release valves are open as they may have
shifted during transit.
Check air controls
Ensure all air controls on the topside of your spa are
turned to the ‘off’ position. Failure to turn off the air
controls will extend your heat up time dramatically.
PREP
AR
A
TION
| 13
