DIVERTER
VALVE MAINTENANCE
If the diverter valve of your hot tub is difficult to
rotate, the reason could be the accumulation of
residues in the valve. Please remove such residues
as soon as possible to prevent damage to the
diverter valve.
In order to do this, please follow these steps:
• Switch off the isolation switch/turn off plug to shut
off the power supply to the hot tub
• Lift and shake back and forth to remove the
diverter valve handle
• Unscrew top cap
• Pull up and remove the valve body
• Wipe the valve body and the valve inner wall
• Lubricate the O-ring with waterproof lubricants
• Reinstall the diverter valve and turn on the power
to the hot tub
Jet maintenance
If you find that the jet rotation speed is slower than
usual, or the jet is sticky to turn, the reason could be
the accumulation of sediment between the jet and
the jet housing.
To remove the sediment, please follow
these instructions:
• Unscrew the jet anti-clockwise
• The jet will get to a point where it is hard to turn
• Twist the jet past this point and keep unscrewing
until the jet comes out of the housing
• After washing the jet with water, spin the rotary
section of the jet (only for rotational jets). Now,
the jet should be able to rotate freely. If it can
still not freely rotate, you can soak the bearing in
a cup of vinegar for one night (cider vinegar can
soften any sediment)
• Wash the jet with water on the next day and then
carry out a rotation test
• You may also need to clean the jet housing to
ensure no sediment is stuck
After these steps are done you can screw the jet back
into the jet housing.
IMAGE TO BE
CHANGED
NOTE:
If the bearing can still not freely rotate, you need
to soak it one more night. If the bearing still does
not rotate, you must purchase a new one.
ENJO
YING
Y
OUR
HO
T TUB
OR
S
WIM
SP
A
| 43
