Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual

Page: 24 / 112

IB IL 24 PSDO 8-PAC
24 / 112
PHOENIX CONTACT 7619_en_05
UM Green LED Monitoring the supply voltage U
M
Off: Communications power not present
Flashing at 1 Hz: U
M
below the permissible voltage range (undervoltage)
On: U
M
present
P
(PROFIsafe,
SafetyBridge
only)
Green LED Status indicator for safe communication
Off: No safe communication
Flashing at
0.5 Hz:
Safe communication running, the controller requests operator acknowledgment
On: Safe communication is running without errors
OUT
0.1 - 3.2
Green/red LED Status of each output
(see “Terminal point assignment” on page 35)
Green: Output at logic 1
Off: Output at logic 0, no error
Red ON: Short circuit/overload of an output
(This diagnostic message is stored temporarily on the module. The message is
stored in the volatile memory and will be lost after a voltage reset.)
Flashing red at
1 Hz:
INTERBUS-Safety only: Parameterized shutdown time of the output exceeded (This
diagnostic message is stored temporarily on the module. The message is stored in
the volatile memory and will be lost after a voltage reset.)
Table 2-1 Local diagnostic and status indicators (Fortsetzung)
In the event of an error (red LED ON or flashing), the output is switched off until the acknowl-
edgment sent by the safe controller is received by the safety module (see also Section “Safe
digital output errors” on page 71).