Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual, Page: 71 / 112

Errors: Messages and removal
7619_en_05 PHOENIX CONTACT
71 / 112
8.1 Safe digital output errors
Table 8-1 Safe output errors
Error cause Error Code
(Hex)
LED Comment Effect Remedy Acknow
ledgme
nt
Hardware fault 001x All OUT:
red ON
The indicated output
cannot be disabled
All module outputs
are in the safe state
Power up with error-
free selftest
Exchange
Yes (1)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2
Shutdown
time was
exceeded
002x OUTy:
Red
flashing
The shutdown time
parameterized for
the output was ex-
ceeded
If the affected output
was parameterized
for two-channel op-
eration, the error is
indicated for channel
1.
INTERBUS-Safety
only.
Affected output is in
the safe state
Check parameter-
ized shutdown time
and correct, if neces-
sary
Check quality of
INTERBUS commu-
nication
Yes (2)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2
Short circuit
or overload
003x OUTy:
red ON
Affected output is in
the safe state
Check actuator
Check connector
and cabling
Check freewheeling
circuit at the contac-
tor
Yes (2)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2
Error at the
output
or short circuit
during the test
005x All OUT:
red ON
Pulse test (brief acti-
vation) at the output
failed
All module outputs
are in the safe state
Power up with error-
free selftest
Exchange
Yes (1)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2
Error at the
output
or short circuit
during the test
006x All OUT:
red ON
Pulse test (brief de-
activation) at the out-
put failed
All module outputs
are in the safe state
Power up with error-
free selftest
Exchange
Yes (1)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2
Hardware fault 0091 All OUT:
red ON
Detected by internal
tests.
All module outputs
are in the safe state
Power up with error-
free selftest
Exchange
Yes (1)
Cross circuit
at the indi-
cated output
00Ax All OUT:
red ON
Cross circuit with an-
other output or with
an external signal
All module outputs
are in the safe state
Remove error
Power up with error-
free selftest
Yes (1)
x = 0 ... 3: OUT0_Ch1 ... OUT3_Ch1;
x = 7 ... A: OUT0_Ch2 ... OUT3_Ch2