Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual

Page: 66 / 112

IB IL 24 PSDO 8-PAC
66 / 112
PHOENIX CONTACT 7619_en_05
When connecting the supply voltages, use the diagnostic and status indicators to check
whether the module has started up correctly or whether any errors are indicated. For instruc-
tions on how to proceed in the event of an error, please refer to Section “Errors: Messages
and removal” on page 69.
Carry out the necessary parameterization. Section “Parameterization of the safety module” on page 47
Documentation for the SafetyProg software
(INTERBUS-Safety)
Documentation for the configurable safety module used
(SafetyBridge)
Documentation for the controller used (PROFIsafe)
Program the safety function. User manuals for the function blocks used
Documentation for the SafetyProg software
(INTERBUS-Safety)
Documentation for the configurable safety module used
(SafetyBridge)
Documentation for the controller used (PROFIsafe)
For PROFIsafe: When verifying the safety function, check
whether the F_iPar_CRC parameter is greater than 0 for all
devices. If not, modify the settings.
Checklist “Validation” on page 104
Quick Start Guide for configuring Inline modules with safe in-
puts or outputs under PROFIsafe on your controller
Perform a function test and validation. Check whether the
safety function responds as planned during programming
and parameterization.
Checklist “Validation” on page 104
Table 7-1 Steps for startup (Fortsetzung)
Step Relevant section and literature