Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual

Page: 40 / 112

IB IL 24 PSDO 8-PAC
40 / 112
PHOENIX CONTACT 7619_en_05
4.1.3 Setting the DIP switches
The module has a 2-pos. and a 10-pos. DIP switch.
The DIP switches are located on the left-hand side of the safety module.
Figure 4-1 DIP switch
2-pos. DIP switch The transmission speed and the operating mode are set via the 2-pos. DIP switch.
10-pos. DIP switch
(address switch)
The protocol (for INTERBUS safety) or the address (for PROFIsafe, SafetyBridge) is set
by the 10-pos. DIP switch.
Default setting / Delivery
state
The following values are preset by default:
Set the DIP switches before assembling the module in the Inline station. The switches
cannot be accessed when the safety module is installed in the Inline station.
A 2-pos. DIP switch
B 10-pos. DIP switch (address switch)
76022004
F-Address
off
on
A
500KBD
2MBD
A
500KBD
2MBD
9 8 7 6 5 4 3 2 1 0
B
B
9 8 7 6 5 4 3 2 1 0
Mode2
Mode1
Mode2
Mode1
Left switch: The transmission speed can be set to 500 kbaud or 2 Mbaud.
Right switch:
(Mode switch)
For INTERBUS-Safety or PROFIsafe, set Mode 1.
For SafetyBridge, set Mode 2.
Transmission speed: 2 Mbaud
Mode switch: Mode 1
Address switch: 3FF
hex
(INTERBUS-Safety)
This address is not valid for a SafetyBridge or
PROFIsafe system.