25
BEFORE STARTING OPERATION
Installing inner attachments
To reinstall all the attachments, perform the procedure in reverse order from step 8 on page 24.
If the attachments are not inserted deep enough, the intended wind velocity performance cannot be
achieved, and it may cause culture failure or insufficient decontamination.
Note:
When installing the fan, attach it to the motor
shaft securely. Manually turn the fan lightly to check
that it does not touch the rear wall and pull the fan
lightly to check that it is firmly secured (Fig. 1).
Note:
When installing the duct, check that 4 pins
(Figure below ) are securely attached in the 4 holes
of the duct (Fig. 2).
Note:
When attaching the fan cover, check that two
hooks on the top of the fan cover are securely
inserted in the duct holes (Fig. 3).
Note:
Position the tray with the front edge bent
down (Fig. 4).
Fig. 1
Fig. 2
Bent
down
Fig. 4
Fig. 3
Duct
Fan
cover
1. Position the center hole of the fan over the
projection of the motor shaft and
push it fully in.
2. Manually turn the fan lightly to
check that it does not touch the rear wall.
3. Pull the fan lightly to check that it does not come
off.
Duct
Summary of Contents for MCO-50ML
Page 103: ...103 MEMO ...
