CHAPTER 2: INSTALLATION OF THE CYBERSTORM MKIII
ATTENTION!
Before starting with the installation of the CYBERSTORM MKIII you should by all means read
this manual, otherwise the board or the computer could suffer damage.
Furthermore, the software has to be installed before beginning to install the
CYBERSTORM MKIII. Please also refer to our warranty conditions (chapter 6) in respect to
unadequate handling and unauthorized repair.
If hard disks or other storage media on which there are unsaved data are connected to the system
into which the CYBERSTORM MKIII is going to be installed, we urgently recommend to make a
safety backup of the hard disk(s) BEFORE installing the CYBERSTORM MKIII. Each new connec-
tion of hardware accessories bears the risk -if ever so small - of a damage to sensitive components
or malfunctions due to improper installation or handling, and in consequence of such a damage or
malfunction, data losses could occur. If the backup on floppy disk seems too slow because of a
large amount of data, ask your retailer if he could take over the backup (e.g. on a streamer) and
re-installation for you, or if you could borrow a streamer, possibly against a small fee. We expres-
sively state that we take over no warranty whatsoever for data losses eventually occuring in case
of the malfunction of the system in consequence of the installation of the CYBERSTORM MKIII.
INSTALLATION OF THE CYBERSTORM MKIII INTO
THE AMIGA 4000
The CYBERSTORM MKIII must be installed in the processor expansion slot of the AMIGA 4000.
This slot is situated between the slot-board and the front drive. The installation of this board is not
very difficult. However if you have no prior experience with installations of expansion boards, still
have some questions after having read the instruction manual, or if you generally prefer, your retai-
ler can carry out the installation, possibly against a small fee. Please take note that the installati-
on must by all means be carried out under obligation of all usual precautions against damages cau-
sed by electrostatic charging.
INSTALLATION OF THE CYBERSTORM MKIII:
1.
Switch off your computer.
2.
Disconnect all cables from the computer (power cable, monitor, mouse, keyboard, other inter-
faces).
3.
On the Amiga 4000 there are only two screws that secure the casing cover, on the back of the
casing on the richt and left.
4.
Carefully remove the housing lid by flapping it up. Should you not succeed in doing so or
should you need further information, please refer to you AMIGA-user manual.
5.
In order to exchange the processor board, it is necessary to remove the hard disk in the rear
34
CHAPTER 2
INSTALLATION
Summary of Contents for CYBERSTORM MKIII
Page 1: ...ANWENDERHANDBUCH USERS MANUAL PAGES 29 55...
Page 29: ...NOTIZEN 27...
Page 57: ...55 NOTES...
