position. For the operation of the CYBERSTORM MKIII they have to be placed in position
"EXT" or "E,". Depending on whether you are using an AMIGA 4000/030 or AMIGA 4000/040,
these jumpers by default are set to on position "EXT" or position "INT". Please take note that
the operation of the CYBERSTORM MKIII is not possible if the jumpers are set to position
"INT", and the computer will not boot in such a wrong position.
8. The carrier board is installed into the computer by means of placing it onto the spacers first,
and then pushing them down (see Figure 4). Please make sure that the board is kept in place
by the spacers and also sits properly in the processor plug.
9. Re-mount the hard disk, complete with its attachment, by reversing the sequence in which you
have taken it out.
10. Finally you close the housing, fasten all screws, and re-connect all cables to the computer in
36
CHAPTER 2
INSTALLATION
Figure 3.
Position of clock
jumpers, which have to
be set correctly.
Figure 4.
Installation of the
CYBERSTORM MKIII.
The circles mark the
positions of the drill
holes, into which the
spacers must be
engaged.
Summary of Contents for CYBERSTORM MKIII
Page 1: ...ANWENDERHANDBUCH USERS MANUAL PAGES 29 55...
Page 29: ...NOTIZEN 27...
Page 57: ...55 NOTES...
