drive as well. In order to remove the hard disk, just loosen the four mounting screws and lift up
the hard disk with its attachment. The connecting cables are long enough so that you can put
down the hard disk on the power supply unit without having to disconnect the cables.
6.
Afterwards, the processor board is taken out of the computer as shown in figure 1. If the board
can hardly be moved, you should take care that the four spacers are also loose. Now the board
can be taken out of the computer by slight tilting. If the spacers sit not on the main board but
on the processor board, you should put these back in their foreseen drill holes on the main
board, as shown in Figure 2. This is required to make the installation of the CYBERSTORM
MKIII system as easy as possible. For owners of AMIGA 4000/030, two additional spacers are
supplied with the delivery.
7.
Before the carrier board is inserted, the two clock jumpers marked on the main board under
the CPU-board with "INT" or "I" and "EXT" or "E," (see Figure 3), have to be put in their proper
35
Figure 1.
Slight tilting to the side
makes it possible to take
the CPU-board out of the
housing after the
connectors have been
loosened.
Figure 2.
The
CYBERSTORM MKIII
has to be placed on
these spacers.
Summary of Contents for CYBERSTORM MKIII
Page 1: ...ANWENDERHANDBUCH USERS MANUAL PAGES 29 55...
Page 29: ...NOTIZEN 27...
Page 57: ...55 NOTES...
