phase 5 CYBERSTORM MKIII, User Manual

Page: 52 / 57

CHAPTER 5
ERROR TRACKING
Error: The computer can't be started
Check if the mains cable has stable contact. If this is so, kindly contact your retailer.
Error: Autoconfig-error
If after the starting of the computer resp. after a reset a red screen appeards with the title "Expan-
sion Board Diagnostics", then please refer to your retailer.
Error: A SCSI unit is not recognized
Check if the unit is conected to the internal power supply.
For external units: Check if the mains cable of the external unit is connected correctly, and if the
unit is switched on.
Check the SCSI ID of the connected units.
Check the connection of the SCSI cable on the CYBERSTORM MKIII SCSI controller and on the
SCSI unit.
For external units check the correct position of the external SCSI cables.
Check the correct SCSI-bus-termination.
If necessary exchange the cable or connect (for internal units) the SCSI unit to another plug of the
cable, to find out eventual errors of the cable.
Error: The partitions of a disk which was formatted earlier are not recognized
First you should check with the program Unit Control which is delivered together with the CYBER-
STORM MKIII if the respective hard disk is physically recognized. If this is not the case, please
carry out the instructions of the previous error description. If the disk is recognized, check if the for-
merly used controller was RDB compatible, and also oblige the step-by-step instruction for the con-
figuration of a hard disk. If with the instructions given there you still can not configure the disk, plea-
se refer to your retailer before you undertake further measures.
Error: During operation of a hard disk, transmission errors occur
Check the correct SCSI bus termination resp. termination of the individual conneted units.
Check the SCSI IDs of the connected units.
Check the correct termination of the SCSI cable. If necesary exchange the cable, to find out pos-
50 CHAPTER 5
ERROR TRACKING