38
CHAPTER 2
INSTALLATION
INSTALLATION OF THE CYBERSTORM MKIII INTO AMIGA 3000(T)
For installation in an AMIGA 3000 resp. AMIGA 3000T please refer to your AMIGA user manual.
For the operation of the CYBERSTORM MKIII in the AMIGA 3000(T) three jumpers on the A3000
mainboard must be set as follows: Jumper BRDCLK to position EXT, jumper CPUCLK to position
INT, and jumper QUADCLK to position EXT. The positionens of the jumpers are described in the
AMIGA 3000(T) user manual.
ATTENTION
The SCSI Controller of the CYBERSTORM MKIII can only be used in the Amiga 3000
Desktop after a modification of the A3000 mainboard, as the CPU slot of the A3000 is missing
an important signal (INT2) which is necessary for the operation of the SCSI
controller. For this modification, one wire must be soldered to connect two pins on the bottom
of the A3000 mainboard. This modification shall only be carried out by
authorized service centers or experienced technicians. A description of the modification is
available from phase 5 digital products on request.
INSTALLATION OF THE CYBERSTORM MKIII IN SYSTEMS WITH AN
A3000/A4000 COMPATIBLE PROCESSOR SLOT
For installation of the CYBERSTORM MKIII in a system with an A3000/A4000 compatible
processor slot, please refer to the installation instructions and jumper setting recommendations
provided by the manufacturer of the system. In any case, the CYBERSTORM MKIII must be ope-
rated with the busclock setting set to "external".
RAM-Bank 0
RAM-Bank 1
Figure 6.
The postion and orientation of
the RAM-Banks on the CYBER-
STORM MKIII.
Summary of Contents for CYBERSTORM MKIII
Page 1: ...ANWENDERHANDBUCH USERS MANUAL PAGES 29 55...
Page 29: ...NOTIZEN 27...
Page 57: ...55 NOTES...
