83
VersiStart p III
10G – Adjustment Lock
Options:
Read & Write
(default)
Allows users to alter parameter values in the
Programming Menu.
Read Only
Prevents users altering parameter values in the
Programming Menu. Parameter values can still
be viewed.
Description:
Selects whether the keypad will allow parameters to be changed via
the Programming Menu.
10H – User Parameter 1
Options:
Blank (default)
Displays no data in the selected area, allowing
long messages to be shown without overlapping.
Motor pf
The motor's power factor, measured by the soft
starter.
Mains Frequency
The average frequency measured on three
phases.
Analog Output
Value
The value of the analog output (refer to
parameters 9A~9D).
Motor Temp (%)
The motor's temperature, calculated by the
thermal model.
Heatsink
Temperature
The soft starter's temperature, measured at the
heatsink.
Bypass Model (%)
The percentage of thermal capacity remaining in
the bypass contactor.
SCR Temperature
The temperature of the SCRs, calculated by the
thermal model.
Rating Capacity (%) The thermal capacity available in the soft starter
for its next start.
Number of Starts
The number of starts the VersiStart p III has
completed since the start counter was last reset.
Hours Run
The number of hours the motor has run via the
soft starter.
Pump Pressure
The pressure at the pump, as configured in
parameters 12D~12F. This information is only
available if the smart card is installed.
Pump Flow
The flow at the pump, as configured in
parameters 12H~12M. This information is only
available if the smart card is installed.
Well Depth
The depth of the well, as configured in
parameters 12O~12Q. This information is only
available if the smart card is installed.
Summary of Contents for VersiStart p III 105
Page 108: ......
