Peri 135413, Assembly, Commissioning And Maintenance Spare Parts And Circuit Diagrams, Page: 6 / 74

6
RCS-2 Climbing Device and Hydraulics
Assembly Instructions
Introduction
These assembly instructions are not a replacement for the assembly instructions for the hydraulic unit, hydraulic cylinder or
complete climbing systems. The instructions for the installed components and systems also apply.
Intended use
The hydraulic system, consisting of the
Climbing Device-2 RCS 50 in combina-
tion with the Hydraulic Unit RCS MAX 2
x 210bar, 380-460V, is used exclusively
for lifting one climbing unit, consisting
of formwork and shoring structure, to
the next concreting section.
The hydraulic system cannot be used
on its own. It has been designed for in-
stallation in a climbing system.
PERI products have been designed for
exclusive use in the industrial and com-
mercial sectors only by suitably quali-
fied, trained and instructed personnel.
These Assembly Instructions serve as a
basis for the project-related risk assess-
ment, as well as instructions for the
provision and use of the system by the
contractor (user). However, they do not
replace them.
The components are to be inspected
before each use to ensure they are in
perfect condition and that they function
correctly.
Only PERI original components may be
used. The use of other products and
spare parts as well as different con-
structional systems and modifications,
represents a misapplication with a po-
tential safety risk. PERI shall not be
held liable in this case.
Changes to PERI components are not
permitted and represent a misapplica-
tion with a potential safety risk.
Safety instructions and permissible
loads must be observed.
Components provided by the contractor
must comply with the requirements
stipulated in these assembly instruc-
tions and all applicable laws and stand-
ards.
Deviations from the standard configura-
tions listed here are generally imper-
missible. Special applications must be
described in the form of detailed plan-
ning and operating instructions based
on a separate risk assessment. These
special applications must be approved
by PERI.
Anything other than the use that is
specified in Point 1 is considered con-
trary to the designated use!
For damage arising from non-intended
use
■
the operator bears sole responsibility,
■
the manufacturer assumes no liability.
Use in a way not intended, deviating
from the standard configuration or the
intended use set forth in the assembly
instructions, represents a misapplica-
tion with a potential safety risk.
Only PERI original components may be
used. The use of other products and
spare parts, represents a misapplica-
tion with a potential safety risk.
Changes to PERI components are not
permitted.
Operation with damaged or incomplete
load-carrying equipment is not permis-
sible.
The system described in these Assem-
bly Instructions may contain patent-pro-
tected components.
Instructions for Use