36
RCS-2 Climbing Device and Hydraulics
Assembly Instructions
D4 Climbing procedure
■
A detailed description of the climbing
procedure can be found in the In-
structions for Assembly and Use for
the climbing system.
■
Observe the assembly instructions
for the hydraulic unit.
Observe the project-specific climbing
procedure diagram and hydraulic con-
nection diagram.
Set the hydraulic unit so it is ready
for operation
1. Check that all pumps are in the cor-
rect operating mode.
2. Press the “Status/Reset” (
3.19
) but-
ton on all hydraulic units until all but-
tons go green, and correct and ac-
knowledge any errors that occur.
→
The pumps are ready for operation.
(Fig. D4.03)
Always extend and retract the climbing
devices until your limit stop is reached.
Synchronisation deviations are thus cor-
rected.
Extend climbing device
1. Press the “Cylinder Extend” button
(
13.1
) on the remote control.
→
The climbing device extends.
(Fig. D4.04)
If multiple remote controls are connect-
ed, they must all be activated simulta-
neously, otherwise the climbing sys-
tem will not move.
3.19
Fig. D4.03
Fig. D4.04
13.1
13.1
Summary of Contents for 135413
Page 58: ...58 RCS 2 Climbing Device and Hydraulics Assembly Instructions F2 Declaration of incorporation...
Page 59: ...59 RCS 2 Climbing Device and Hydraulics Assembly Instructions F2 Declaration of incorporation...
Page 61: ...61 RCS 2 Climbing Device and Hydraulics Assembly Instructions F2 Declaration of incorporation...