P
P
E
E
S
S
1
1
9
9
0
0
0
0
G
G
i
i
G
G
S
S
M
M
R
R
e
e
p
p
e
e
a
a
t
t
e
e
r
r
PES1900NR Operations Manual
Chapter 5. Installing the Growth Cabinet — 79
Figure 54 Bell Housing Unit Installed
Installing the RF Cable at the Growth Cabinet
In the preceding section, you connected the RF cable, to the Main Repeater. In this section, you
connect the opposite end of the RF cable conduit, to the Growth Cabinet.
1. Remove the Lock Nut from the unattached conduit connector elbow.
2. Thread the cables from the bottom of the entry box on the Growth Cabinet, through the
opening, as shown
3. When the cables are inside the entry box of the Growth Cabinet, feed them through the Lock
Nut.
4. Connect the ribbon cable.
5. Connect the RF cables, using a 5/16-inch wrench. Do not over-tighten.
6. Secure the Lock Nut to the entry box, using channel-lock pliers to tighten.
7. Figure 54 shows the completed cable installation to the Growth Cabinet.