DRAFT
MTSE
IO&M Manual
12
Paragon Controls Inc,
Rev J 2/3/2021
4. MENU INFORMATION
4.1.
Levels of Menus
The following is a tree view of the available menu pages on the bottom of the Normal Active Display
(see Figure 3.1). Pressing one of these menu buttons loads a separate menu as described below. An
icon with a back-arrow key is present in every menu page in the lower left corner of the screen. This
arrow key will take you back to the previous page.
NO
RMA
L
A
C
TIV
E
DISP
LA
Y
SETUP MENU
All job specific parameters and configuation
information is entered here (See Section 4.2)
DIAGNOSTICS
Sensor Data Page
View flow rate and pressure data for each
individual sensor
System Overview
View system and parameter configuration
information
Factory Defaults
Reset MTSE to Factory Default Settings
(Caution - resetting will remove parameters
set in the field)
Software Update
If instructed by the Factory, software can be
upgraded by inserting new microSD (uSD) card
Screen Saver Mode
Toggle On or Off Screen saver
Factory
Password protected factory configuration menu
AutoZero Settings
(only available when AZ is ordered)
Initiate true AutoZero by pressing Run AutoZero
Enable/Disable AutoZero
AutoZero Interval
(in hours)
K-FACTOR
Shortcut button to K-Factor Page in Setup Menu
NOTIFICATION
Alarms and other warnings are visible here
? (INFORMATION)
Company information and software revision are
visible here
Troubleshooting information is also visible with
the right arrow
