Manual
76
8.3.6
Configuration process
To enter the number of points, press
and enter the desired value (3 up to 300 points are possible).
Confirm the entry by pressing
. Make sure, that all points are placed on the current part (splice). If the
field “Splice no.” displays “-“, there is only one part.
If the distances between all points ( in all splices) are the same, press
and activate the “Equal
Distances” checkbox. Press
now, to reach the field of distance entry, enter a value and confirm by
pressing
.
The entered value is used for all distances, if the checkbox “Equal Distances” is activated.
If the distances between the points are not equal, use
and
, to select a point and press
, to
enter the distance to the next point. Repeat the process for all points (except for the last one).
Note:
If you use more splices, check the splice number displayed at “Splice no.”, to check in which part
you are currently situated. The distance between two overlap points cannot be edited.
To add a new splice, press
and add “1” to the current “Splice no.” (if the current value is “-“, enter
“2”). Configure the new splice after that.
If you want to change parameters, press
, to reach the parameter screen. Here you can
activate/deactivate the manual data entry by pressing
or the manual angle entry by pressing
.
Pressing
makes it possible to switch between the measurement units mm and inch. Press
,
to use the sensor S as your aim and press
, if you want to use an external laser. For averaging, press
, enter a probe number and confirm by pressing
.. Press
to save and exit the parameter
menu.
8.3.7
Carry out measurements
Press
in the main screen of the program, to get to the measurement screen.
What should be noted in this window
Shortcuts in this window
Carry out rough alignment of the laser,
when you start a new measurement
Delete measurement point
Functions in this window
Manual entry of detector value
(V)
-
Carry out measurement
-
Enter data manually (if activated)
Manual entry of detector value
(H)
Change measurement units
Open context menu
Navigate forward/backward
through the points
8.3.8
Duration of the connection establishment
Depending on which interface is used to connect the sensors (Bluetooth or serial), the connection
establishment can take between 2 and 30-40 seconds. It is recommended to wait about 10 seconds
(cable connection) or about 50 seconds (wireless connection). If no connection is established after that
time, check the sensors and the system settings of the PCE-TU 3.
