Manual
20
the value.
The absence of the laser beam position indicator and a red blinking frame of the
position indicator mean, that no laser beam meets arrives or no sensor data are
recognized.
An empty dial means that there is currently no angle established (or averaging is
not completed ) or that the rotation angle (to the next position) is too small (lower
than 6°)
A bright red indication means that the rotation angle does not meet the
requirements of the single measurement points (at least 60°).
A yellow indictaion means that the rotation angle is over 60°.
A green indication means that the rotation angle is over the recommended area
(over 90°).
This symbol means that an expanded Y-value range is used.
A crossed-out symbol means that the auto-sweep mode is deactivated.
This symbol means that the auto-sweep mode is activated.
Serial number of the
sensors. “No sensor”, if no
data can be received
Current
measurement/number of
measurements
Alignment type
H- horizontal
V - vertical
Angle of stationary and
moveable side
Manual angle
Note-Box
Dial with
measurement points
and the graphically
displayed angles
Entire rotation
angle; needs to be
larger than 60°
Laser beam position
indication
Auto-Sweep status
