Manual
54
7.7.8
Display overview
To carry out (and save) a measurement or to replace a measurement, press
. Use
and
, to switch between the measurement points (positions). Always pay attention to the current
selected side of the shaft and switch it (if recommended) by pressing
.
7.7.9
View and save results
If the measurements for all measurement points are finished, press
,to display a result. There are two
reference line models you can chose between by pressing
.
Ref.point Mode: if one of the reference points is undefined, the result is the unchanged receiver value. If
two reference points are defined, the result is the difference between the calculated reference line and the
receiver value.
To define reference points, press
and enter reference point number 1 and reference point number 2.
Press
to confirm. In order to delete a reference point, enter
as the value.
Best- Fit Mode: in this mode, the result is the difference between the calculated best fit reference line and
the receiver value.
The result can be displayed as a table or a graph. Due to
, you can switch between these illustrations.
Laser beam is out of
aim
Not ready (wait)
No connection to the
sensors
Receiver values „-
,--
„ means that
data are not ready
Inclination indication:
Blue area shows the
allowed position
Inclination value
should be entered
manually for every
side
Inclination indication of
the saved
measurements
Y-, X- and inclination
value of the saved
measurement
Switch to the opposite side
(12 and 6 o’clock)
Current point number
Laser beam position
indicator
Saved measurements
for the current
measurement point
Saved result for the Y-
Axis
Saved result for the X-
Axis
Number of the
measurements current
measurement point
