WD-Z2 Series Installation Guidelines Rev.5
- 47 -
14.
Reference 9: Using WDT-5LR-Z2/WDT-6LR-Z2 in WDS-AUTO2
In WDS-AUTO2, the WDT monitoring status ("0", "9") output is exported as CSV data to the signal wire
information string specified in the transmitter's power settings.
Therefore, when the CSV output is set in (2-1), it is necessary to set one of the signal wires as the transmitter's
power settings.
In order for the data to be collected correctly by WDS-AUTO2, set the following for WDT-5LR-Z2/WDT-6LR-Z2.
(1) WDT-5LR-Z2/WDT-6LR-Z2 (power settings)
Specify "Signal wire color" in the power settings.
Operation settings
Setup value
Power supply settings
Select signal wire colors in which data will not be collected, outside
the wire to be used for “Power Supply Setting”.
*Signal wire color selection: Red, yellow, green, blue, white
CAUTION
If the "Power supply wire" is specified for the power settings, the WDT monitoring status (“0”, “9”) output will
not be generated as CSV data.
Moreover, since the WDS-AUTO2 will determine the transmitter has an invalid state, be sure to select
anything other than "Power supply wire".
(2) Select Signal Tower information format
Select the “Standard Format”.
DIP Switch
Setting
No3
OFF (Standard Format)
CAUTION
The WDT-5LR-Z2/WDT-6LR-Z2 does not support the extended format, so always select the standard format.
WDT-5LR-Z2/WDT-6LR-Z2 are shipped with the standard format as the factory default value.
