WD-Z2 Series Installation Guidelines Rev.5
- 26 -
(2) Receiver Installation
Because the installation location is always in a high place, do the installation only after completing the initial
settings (wireless settings, LAN settings, etc.).
Install the receiver in the location (position, height, direction) described in the “Radio Wave Environment
Investigation Report”.
The installation location requires LAN wiring and a 100 VAC outlet for the AC adaptor.
When storing the receiver in a box, use a plastic box, etc., with radio wave permeability.
Important
When determining the installation location, carefully review the "About the receiver installation location"
below.
Because the WD is a product that uses wireless communication, a poor installation location could cause
problems such as unstable operation or communication failure.
(2-1) Receiver installation location
(2-1-1) Receiver position
①
Radio reception with the receiver at the center of the area [
◎
Very good]
- The receiver seeks out equipment in all directions, so an optimal mesh network can be
configured.
②
Radio reception with the receiver installed on a wall in the center of the area [
○
Good]
Equipment
Receiver
Receiver at the center of a 20m radius
