WD-Z2 Series Installation Guidelines Rev.5
- 14 -
③
Receiver's LAN setting Adjustment
- Get the number of receivers with IP addresses connected to the internal LAN.
Setup Item
Initial value
IP address
192.168.0.1
Subnet mask
255.255.255.0
Default gateway
0.0.0.0
DNS server
0.0.0.0
Port number
10001
*Enter the settings in the receiver initialization sheet.
CAUTION
When operating the WDS-AUTO2/WDS-WIN01, do not change the initial values of the DNS server.
Use the default value for the port number.
Note
- For other WDT check items, the explanation in this manual is based on the following default values.
Transmitter Setup Item
Reference
LME / LE Series
LR series
Display firmware version
Version information of the transmitter in use is used for
inquiries and checking for version updates, etc.
Connection allowed
(Default Value: Permitted)
Set to “Permitted” or “not permitted” for the transmitter relay
function. (The default value is recommended)
Transmission Mode
(Default Value: Immediate transmission)
The timing is set for when the Signal Tower changes or
when a request is received from the host while the
transmitter is transmitting data.
Simple counter function
(Default Value: Do not use)
Not
applicable
Set if the simple counter function is being used.
Counter upper limit value
(Default Value: 4294967295)
Not
applicable
Used when “counter mode” and “simple counter” are
enabled.
- Other WDR check items.
Receiver Setup Item
Reference
Display firmware version
Version information of the receiver in use is used for
inquiries and checking for version updates, etc.
MAC Address
Used to identify the receiver installed in each area. If using a
LAN connection, the receiver can be identified by its IP
address and is labeled on the receiver’s wireless module.
This can also be checked by using the setup tool.
*Refer to the "WD-Z2-specific System Settings Application Operation Manual" and "WDS-WIN01
Instruction Manual" for details on each function.
