WD-Z2 Series Installation Guidelines Rev.5
- 12 -
Step 5. Device Settings List
●Purpose
After investigating the “Radio Wave Environment” and target equipment, first group the equipment based on the
floor layout and verify the WD settings, then group the equipment according to the layout diagram, etc. of the
factory, and verify the WD setting contents.
①
When filling out the target equipment worksheet list:
Item
Check content
Determine the WD
compatibility
Determine the WD compatible Signal Towers based from the target equipment
investigation results. If an LR / LME / LE series is mounted on an existing Signal
Tower, enter "Y", otherwise enter "N".
Replacement model
For equipment marked "N", after checking the specs for the current signal tower LR
series, fill in the investigation worksheet with the replacement model.
* For details on signal tower models, refer to "Reference 6: Signal Tower Model ".
②
When filling out the transmitter initialization check sheet list:
Item
Settings
①
User Name
Use in "
Step 8. System Operation Check".
②
MAC Address
*1 Check this item in "Step 6. WD Initial Set".
③
ExtendedPanID
*2 Referring to this table note, describe how the groups are divided.
④
Wireless Channel
Describe the wireless channel for each group based on the “Radio Wave
Investigation” results.
⑤
Flashing Cycle
*3 Referring to this table note, define the settings for Determining Signal Tower
Input.
⑥
Power Supply Wire
*4 Referring to this table note, set the display colors for the WD power supply
wires.
*1 Transmitter MAC address
Identify the transmitter mounted on the unit.
The MAC address is on the wireless module of the transmitter. It can even be checked in the setup tool, but it
is more efficient if the address is registered while doing the work.
*2 Create an equipment list
Create a list for a group of around 20 targeted equipment (maximum 30 units) based on the factory layout
diagram for grouped equipment and register the same ID as the group number in the
ExtendedPanID
property
for the transmitter and receiver.
